Product specifications
Model
|
Thickness（mm）
|
Wide（m）
|
Length（m）
|
Lap edges
|
Execution standards
|
Type P (fabric reinforced)
|
1.5
|
2.0
|
20
|
weld
|
GB27789-2011
|
Product features
1. High-quality imported low-carbon and environmentally friendly polymer raw materials and weather-resistant improved formulas;
2. No chlorine components, no open flame construction, no smoke emission, green environmental protection;
3. Excellent weather resistance, UV resistance, aging resistance far beyond the national standard, to meet the ≥ 5000H testing requirements;
4. Excellent physical properties, tensile and tear strength;
5. Strong wind resistance, hail resistance and fire resistance;
6. High sunlight reflectivity, effectively reduce roof temperature, energy saving and emission reduction.
Technical indicators
Executive standard: GB27789-2011 "Thermoplastic polyolefin TPO waterproofing membrane"
|
Serial number
|
project
|
index
|
|
H
|
P
|
|
1
|
The thickness of the resin layer on the intermediate tire base/mm≥
|
-
|
0.40
|
|
2
|
Tensile properties
|
Maximum pull/(N/cm) ≥
|
-
|
250
|
|
Tensile strength/MPa ≥
|
12.0
|
-
|
|
Elongation at maximum pull/% ≥
|
-
|
15
|
|
Elongation at break/% ≥
|
500
|
-
|
|
3
|
Low temperature bending
|
-40℃无划痕
|
|
4
|
Seam peel strength/(N/mm) ≥
|
4.0或自粘卷材破环
|
3.0
|
|
5
|
Right angle tear strength/(N/mm) ≥
|
60
|
-
|
|
6
|
Artificial climate accelerates aging
|
Time/h
|
5000上面
|
|
Appearance
|
No blistering, cracks, delamination, bonding and holes
|
|
Maximum pull retention/%≥
|
-
|
90
|
|
Tensile strength retention/%≥
|
90
|
-
|
|
Elongation retention at maximum pull/%≥
|
-
|
90
|
|
Elongation at break retention/%≥
|
90
|
-
|
|
Low temperature bending
|
-40°C without cracks
|
Construction steps
Mechanical fixation method: base layer cleaning → laying air insulation layer → laying insulation board → pre-laying coil → fixed coil → lap treatment → node strengthening → self-inspection and acceptance
Full adhesion method: base layer cleaning → pre-laid coil → large surface gluing → laying coil → lap treatment → node strengthening → closing treatment → self-inspection and receipt
Empty topping method: base layer cleaning → pre-laid coil → lap treatment → node reinforcement → self-inspection → cover the topping
